A furnace that runs but will not heat is most often held up by a worn ignitor, a dirty flame sensor or a safety switch that keeps tripping. A technician can test each part in a single visit. Call the number on this page to be connected with a local heating company in Bedford.

Sounds that point to trouble
Repeated clicking suggests an ignition problem. A loud bang when the burners start, a rattle from the blower or a squeal that rises and falls each deserve attention. A furnace that is simply quiet and cold, with the house dropping, may have tripped a safety. Describe the sound when you call; it helps the technician bring the right parts.
Attic and closet furnaces
Many furnaces in this region sit in an attic or a hall closet, where heat, dust and tight clearances take a toll. Summer attic heat ages wiring and boards, and cramped closets restrict return air. Both can lead to overheating, limit switch trips and early failures that show up when winter finally arrives.
Before work starts in Bedford
Texas requires anyone contracting for air conditioning and refrigeration work to hold an ACR contractor license from the Texas Department of Licensing and Regulation (TDLR). Ask for the license number and check it on TDLR's license search.
Gas furnaces here are served by Atmos Energy. If you smell gas, leave the house, call 911, then call Atmos Energy at 866-322-8667 from outside.
Bedford's Building Inspections office requires a mechanical permit for replacing or changing out heating and cooling equipment, so ask whether the contractor will pull it.
Power outages here go to Oncor at 888-313-4747, not to your retail electric provider. If the AC and the lights are both out, check that first.
Companies that take calls here usually also work in Fort Worth, Hurst and Euless.
Questions that keep the bill clear
- What exactly failed, and can you show me?
- Is the diagnosis fee applied to the repair?
- Is the part new, and does it carry a manufacturer warranty?
- Are there other worn parts likely to fail soon?
What the company should explain
Before the visit ends, ask what was found, what was replaced and what to monitor. Good follow-up advice is short: stay on top of filters, leave the vents open, and phone again if the same fault returns. Hold on to the invoice in case a part is covered.
Repair or replace the furnace?
A furnace past its normal service life, one needing repeated repairs or one with a safety defect may be better replaced than patched. A repair is reasonable for a young unit with a single failed part. Ask the technician for an honest read on age, parts and the risks of waiting.
Furnace Repair questions in Bedford
My carbon monoxide alarm went off. What do I do?
What should I do if I smell gas near the furnace?
Why does my furnace smell when I first turn it on?
Should I repair or replace an old furnace?
More AC and heating services in Bedford
Furnace Repair nearby
Sources
Last updated: