Furnace repair covers problems such as no heat, a furnace that shuts off early, a pilot or igniter that will not light, and strange noises. A national guide puts furnace repair at about $135 to $422 per job. Call the number on this page to be connected with a local heating company in Fort Worth.

Common furnace problems
Gas furnaces in Fort Worth sit idle for months, then have to work on the first hard freeze. That is when worn igniters, dirty flame sensors, clogged filters, failed blower motors and tripped safety switches show up. Heat pump homes have a different set of issues, and those are covered on the heat pump page. A furnace that is several years old and was never serviced is the most likely to quit when the first cold front arrives, so a no-heat call in early winter is common across Fort Worth neighborhoods with older attic or closet units.
- No heat, or heat that comes and goes.
- The furnace starts, runs briefly and stops.
- Clicking without ignition, or a burner that lights and drops out.
- Loud banging, squealing or rattling from the cabinet.
- Uneven heat from room to room.
Check these first
Set the thermostat to heat and above room temperature, look at the filter, and make sure the furnace switch near the unit is on. If nothing changes, stop there. Do not open the burner compartment, work on gas lines or touch the electrical panel.
If you smell gas
- Leave the house right away, and take everyone with you. Do not flip switches, use a lighter or start a car in the garage.
- From outside and a safe distance, call 911.
- Then call Atmos Energy, the gas utility for Fort Worth, at 866-322-8667. Atmos says not to assume someone else has already reported it.
- Stay out until the utility or the fire department says it is safe. Only after that should a heating company look at the furnace.
Carbon monoxide
If a CO alarm sounds, get everyone out and call 911. The Consumer Product Safety Commission recommends a yearly professional inspection of the heating system.
What happens on the call
Say what the furnace does and does not do, its age and where it sits. Ask what the company charges to come out and whether that amount is applied to a repair. Many companies take after-hours calls; ask when you call.
Cost, license and permits
A national guide lists furnace repair at roughly $135 to $422 per job. Fort Worth prices can differ. Check the company on TDLR's license search, since heating work falls under air conditioning and refrigeration contracting. Fort Worth's Development Services office says repairing mechanical equipment can require a mechanical permit, so ask the company how it handles that.
Furnace Repair questions from Fort Worth homeowners
Why is my furnace blowing cold air?
What do I do if I smell gas?
How much does furnace repair cost?
Should I check the contractor's license?
Related AC and heating services in Fort Worth
Helpful guides
Furnace Repair in nearby cities and towns
Tarrant County
Johnson County
Parker County
Hood County
Denton County
Wise County
Sources
Last updated: