A furnace that runs but will not heat is most often held up by a worn ignitor, a dirty flame sensor or a safety switch that keeps tripping. A technician can test each part in a single visit. Call the number on this page to be connected with a local heating company in Haslet.

Sounds that point to trouble
Repeated clicking suggests an ignition problem. A loud bang when the burners start, a rattle from the blower or a squeal that rises and falls each deserve attention. A furnace that is simply quiet and cold, with the house dropping, may have tripped a safety. Describe the sound when you call; it helps the technician bring the right parts.
Control board and blower issues
The control board runs the ignition sequence and reads each switch. When it fails, or when a blower motor or capacitor weakens, the furnace can stall in odd ways: no response, repeated restarts or a blower that will not stop. Those faults take a meter and a methodical test to sort out.
Homes farther out from Haslet can mean longer drives for the company, so give clear details about the furnace and its location when you call.
Small part, big part
Replacing a ignitor or flame sensor is a modest repair. An inducer motor, gas valve or control board is a bigger one, and a heat exchanger is a different category altogether. Before agreeing to a major part, ask whether the furnace is old enough that the money would be better put toward a replacement.
Permits, power and gas in Haslet
Before you approve the work, check the company's ACR contractor license with TDLR; the state agency also takes complaints about AC contractors.
Gas furnaces here are served by Atmos Energy. If you smell gas, leave the house, call 911, then call Atmos Energy at 866-322-8667 from outside.
Repairs usually don't involve the city, but installs and change-outs may; the city's building department can confirm what needs a permit.
Power outages here go to Oncor at 888-313-4747, not to your retail electric provider. If the AC and the lights are both out, check that first.
Calls from Haslet are often matched with companies that also cover Fort Worth, Saginaw and Keller.
A good diagnosis sounds like this
You should hear which component failed and why, not just that the furnace needs work. A technician should also tell you whether the cause was a wear item or something upstream, like restricted airflow, that will cause the same fault again. Ask questions; a clear answer is a good sign.
Why CO alarms matter at the first cold snap
Homes are closed up, furnaces run for hours and vent problems show up when the first cold night arrives. Check that CO alarms work and have fresh batteries before the cold hits. If one sounds, treat it as real, leave, and call 911; do not wait to see if it stops.
Furnace Repair questions in Haslet
Why does my furnace keep shutting off after a few minutes?
Why does my furnace smell when I first turn it on?
How do I know a heating company is qualified?
Will a furnace repair fix my high heating bills?
More AC and heating services in Haslet
Furnace Repair nearby
Sources
Last updated: