AC and heating referrals for Fort Worth & nearby townsCall: (817) 623-4802
(817) 623-4802

How much does AC repair cost in Fort Worth?

acrepairfortworth.net

AC repair prices vary a lot by the part that failed, the age of the system and the refrigerant it uses. This guide lists sourced price ranges, says where each number comes from, and shows how to compare quotes from local companies.

Need AC help now?
Call now to be connected with a local AC and heating company in Fort Worth.
(817) 623-4802

AC repair prices vary a lot by the part that failed, the age of the system and the refrigerant it uses. This guide lists sourced price ranges, says where each number comes from, and shows how to compare quotes from local companies.

Quick cost estimator

Typical ranges from the sources cited below, not a quote. The company you hire will price the actual job.

Short answer: a wide range, and the part decides most of it

No single number answers this question honestly. A national cost guide puts a typical AC repair between $150 and $650 per job. That range covers a failed capacitor at the low end and a bigger component at the high end. The figures below are published ranges from cost guides, not quotes. Fort Worth companies set their own prices, and the only price that matters for your house is the one a company gives you after looking at your system.

If your AC is running but the house will not cool, the cause could be anything from a dirty filter to a failed compressor. The checklist for an AC that runs but does not cool covers the free things to check before you call anyone. If you have already done that, this guide helps you read the quote you get.

Common AC repair costs, with sources

These ranges come from the published cost guides listed at the bottom of this page. Where a figure is national, it says so. Texas figures are from a Texas price guide for a 3-ton system in a 2,000 square foot home. Neither is a Fort Worth price list, so treat them as a rough frame.

JobPublished rangeArea of the source
AC repair, typical$150 to $650National
Service call or diagnostic fee$75 to $200National
Capacitor replacement$200 to $400National
Refrigerant recharge, R410A$100 to $320National
Refrigerant recharge, R22$180 to $600National
Refrigerant leak repair and refill$200 to $1,500National
Evaporator coil replacement$400 to $2,400National
Compressor replacement$600 to $2,500National
Tune-up or maintenance visit$70 to $200National
Central AC replacement, 3-ton, 2,000 sq ft home$3,800 to $4,500Texas

The evaporator coil and compressor figures each split into a lower range when the part is under a manufacturer warranty and a higher range when it is not. If you think a part may still be covered, find your system's data plate and paperwork before the visit, and ask the company how a warranty claim would work. Do not assume it will apply.

What pushes a repair toward the high end

Several things move the price within a range. Knowing them helps you ask better questions.

  • The failed part. A capacitor is a small, common part. A compressor or an evaporator coil is a major component, and the labor to swap it is larger too.
  • Refrigerant type. Systems that use R22 cost more to recharge than R410A systems in the sourced figures above. EPA states that production and import of R22 has ended, and that owners of existing R22 systems may keep using them, supplied by recovered and reclaimed refrigerant. Our guide to refrigerant leaks and R22 explains what that means for an older system.
  • Access. Many North Texas homes on slabs have the air handler in a closet or in the attic. A tight attic in summer slows the work.
  • Whether it is a leak or a top-off. Adding refrigerant to a system that is low does not fix why it is low. A recharge with no leak search can mean paying for the same repair again.
  • Timing. During a run of hot days, many companies are busy, and some charge more for after-hours calls. Ask about it when you call.

The diagnostic fee

A diagnostic or service call fee is the charge for sending someone to find the problem. The national range in the table is $75 to $200. Policies differ. Some companies credit the fee toward the repair if you go ahead with them, some do not, and some include it in a flat rate. Ask three things on the phone: what the fee is, whether it applies to the repair, and what happens if you decide not to proceed. Get the answer before the visit, not after.

Repair now, or is this a replacement conversation?

When a quote is for a major component on an older system, the real question is whether the money goes into a repair or toward a new system. A Texas price guide lists $3,800 to $4,500 for a 3-ton central AC replacement in a 2,000 square foot home, and a national guide lists a much wider $5,000 to $12,000 for central AC installation. Those two ranges disagree because the scope differs. One is a like-for-like swap, the other includes jobs with new ductwork, larger systems and added equipment. Read how to decide between repair and replacement before you approve a large repair on an old unit. Fort Worth also requires a mechanical permit for changing or moving mechanical equipment, including a central heating and air conditioning system, so ask who pulls the permit on any replacement.

How to compare quotes properly

  1. Ask for the quote in writing, broken into parts, labor and any fees. A single lump figure hides what you are paying for.
  2. Ask what failed and why. A good answer names the part and the reason. "It needs freon" is not a diagnosis.
  3. Ask about the refrigerant. Which type does your system use, and if it is low, where is the leak?
  4. Compare like with like. A quote that includes a leak search and one that only tops off refrigerant are different jobs.
  5. Check the license before work starts. TDLR states that anyone offering air conditioning and refrigeration contracting services in Texas must hold an ACR contractor license. TDLR's online search shows whether a business holds one. Our walkthrough on checking a Texas AC contractor's TDLR license takes a couple of minutes.

Technicians who work on refrigerant-containing equipment must also hold EPA Section 608 certification, and EPA rules prohibit intentionally venting refrigerant while servicing equipment. It is fair to ask the company about both.

Keeping repair bills smaller

Many expensive AC failures begin as small maintenance problems. The Department of Energy advises routinely replacing or cleaning filters, checking the evaporator coil every year, clearing debris from the outdoor condenser and passing a stiff wire through the drain channels now and then to prevent clogs. In Fort Worth, where DFW normals show an average of about 20 days a year at 100 degrees or higher, the system works hard for months. A tune-up in the sourced range of $70 to $200 per visit is small next to a coil or compressor bill. Our AC maintenance checklist for Fort Worth homes lists what to do yourself and what to leave to a pro. Drain line trouble is one of the most common summer calls, and the guide to AC drain line clogs explains the warning signs.

Some jobs are never a homeowner job. Do not open an electrical panel or handle refrigerant yourself. If you smell gas at any time, leave the house, call 911, and then call the gas utility from outside. Atmos Energy is 866-322-8667 for most towns; Texas Gas Service is 800-959-5325 for Weatherford, Willow Park, Hudson Oaks and Aledo.

One more habit worth having

Keep a simple record of every repair: the date, the part, the price and the company. When a quote for a large part arrives years later, that record shows whether the system has been a steady performer or a repeat customer for repairs, and it makes the repair-or-replace choice much easier. Photograph the data plate on the outdoor unit while you are at it, so the model, serial number and refrigerant type are on your phone when someone asks.

Get connected with a local company

Call now to be connected with a local AC and heating company in Fort Worth.
(817) 623-4802

This site is a free referral service. We are not an HVAC company and we do not set prices. The call connects you with an independent local AC company that can look at your system and quote the work. You can read about each job on our Fort Worth AC repair page, see a part-specific page such as capacitor and fan motor repair or compressor repair, or browse all services. If you live outside the city, find your town on the service areas page.

Frequently asked questions

What is a typical AC repair cost?
A national cost guide gives $150 to $650 per job as the typical range. A Fort Worth company may quote above or below it depending on the part, the refrigerant and how hard the unit is to reach. Treat the range as a starting frame, not a price list.
Is the service call fee separate from the repair?
It can be. A national guide lists $75 to $200 for a diagnostic or service call. Some companies apply it to the repair and some do not, so ask before the visit.
Is it worth repairing an old AC?
It depends on the part and the system. A capacitor on an older system is usually a small repair. A compressor or coil quote on an old unit is where replacement deserves a real comparison.
Why does an R22 recharge cost more?
In the sourced figures, an R22 recharge runs $180 to $600 against $100 to $320 for R410A. EPA states R22 production and import has ended, so the supply comes from recovered and reclaimed refrigerant.
How do I know a company is allowed to do the work?
Texas requires an ACR contractor license from TDLR for air conditioning and refrigeration contracting. Search the company's name on TDLR's online license search before work starts.
Call now to be connected with a local AC and heating company in Fort Worth.
(817) 623-4802

Last updated:

☎ Call (817) 623-4802