AC and heating referrals for Fort Worth & nearby townsCall: (817) 623-4802
(817) 623-4802

AC running but not cooling: what to check first

acrepairfortworth.net

When the AC runs but the house stays warm, a few safe checks can sometimes find the cause in minutes. This list goes from the simplest to the point where you should stop and call a local company.

Need AC help now?
Call now to be connected with a local AC and heating company in Fort Worth.
(817) 623-4802

When the AC runs but the house stays warm, a few safe checks can sometimes find the cause in minutes. This list goes from the simplest to the point where you should stop and call a local company.

Before you start

These checks are limited to things a homeowner can do safely: looking, listening, changing a filter and resetting a thermostat. Never open an electrical panel, never open the outdoor unit's wiring compartment, and never handle refrigerant. If you smell gas at any point, leave the house, call 911, and then call the gas utility from outside. Atmos Energy is 866-322-8667 for most towns; Texas Gas Service is 800-959-5325 for Weatherford, Willow Park, Hudson Oaks and Aledo. If a carbon monoxide alarm sounds, get everyone out and call 911.

North Texas gives air conditioners a long season. DFW normals show July and August highs around 95 degrees and roughly 20 days a year at 100 or above, with some summer nights staying above 80. A system that was fine in May can show its weak spots in July, which is why a no-cooling call often comes during the hottest stretch.

1. Check the thermostat

  • Confirm it is set to cool, not heat or off, and that the target is several degrees below the room temperature.
  • Set the fan to auto. If the fan is set to on, it runs constantly and can blow lukewarm air between cooling cycles.
  • If the screen is blank or dim, replace the batteries. A dead thermostat can leave the system doing nothing or the wrong thing.
  • Check that a schedule or hold setting is not overriding what you set.

If the thermostat itself is acting up, our thermostat repair and installation page explains what a local company can do.

2. Check the air filter

A clogged filter restricts airflow across the evaporator coil. The Department of Energy advises routinely replacing or cleaning air filters for exactly this reason. Pull the filter and hold it up to a light. If you cannot see light through it, replace it with the right size. Fort Worth dust, cottonwood fluff and pet hair clog filters faster than many people expect, especially when the system runs most of the day.

3. Look at the outdoor unit

Go outside, standing clear of the unit, and look without touching anything electrical.

  • Is the fan spinning? If the system is calling for cooling and the fan is still, that points to a failed fan motor or capacitor, or a power problem. Do not poke at it.
  • Is it humming but not starting? That sound often goes with a failed capacitor or a stuck motor. Turn the system off at the thermostat so the unit is not straining.
  • Is the coil covered? Cottonwood fluff, grass clippings, leaves and dryer lint on the fins block airflow. DOE advises clearing debris from the outdoor condenser. With the power off at the thermostat, you can remove loose debris from around the unit and keep plants a couple of feet back. A gentle rinse of the outside fins is a common maintenance step, but never spray into the unit's electrical parts.
  • Are the fins bent flat? Hail can damage the fins, which restricts airflow. That needs a professional.

Settling clay soil around North Texas homes can also tilt a condenser pad over time. A unit that has visibly shifted should be looked at.

4. Check for ice

Look at the copper line that runs into the house from the outdoor unit, and at the indoor air handler if you can see it safely. Frost or ice on the lines or the coil is a clear warning. Ice usually means airflow is poor, or the system is low on refrigerant. In either case, running the AC makes it worse.

  1. Switch the thermostat to off.
  2. Set the fan to on to help the ice melt.
  3. Let it thaw for several hours. Expect water. Make sure the drain pan and the area around the air handler are not overflowing.
  4. Replace the filter. If the ice returns, call a local company.

If water pools around the indoor unit, a blocked condensate drain may be the cause. Our guide to AC drain line clogs and water around the air handler explains it, and the drain line service page shows what a pro does.

5. Check vents and returns

Walk the house. Are the supply vents open and unblocked by furniture or rugs? Is the return grille clear? Is air coming out strongly, weakly or not at all? Weak airflow at every vent suggests a filter, blower or coil problem. Weak airflow in one room only suggests a duct problem such as a crushed or disconnected run in the attic. Attic ducts in North Texas homes take a lot of heat and a lot of abuse. See ductwork repair and replacement if one area never cools.

6. Check whether the system lost power

Storm blips and heavy summer demand can trip a breaker or interrupt the system. Look at the thermostat to see if it has power. If you suspect a tripped breaker, you may reset it once at the panel if you can do so safely without opening internal parts. If it trips again, stop. A breaker that trips repeatedly is warning you about a fault. Retail electric choice means you buy power from a provider, but the local utility, Oncor in most of the Fort Worth area, maintains the wires and restores service during an outage. For a power outage, contact the utility, not an AC company.

What the symptoms often point to

What you noticeOften points toWho handles it
Warm air, weak airflow everywhereDirty filter, frozen coil, blower troubleYou for the filter, a pro for the rest
Outdoor fan not spinning, hummingFailed capacitor or fan motorA pro
Ice on lines or coilPoor airflow or low refrigerantA pro
Hissing, bubbling, oily residue near linesRefrigerant leakA pro with EPA 608 certification
Water around the indoor unitClogged condensate drainYou can look, a pro can clear
Breaker keeps trippingElectrical fault or failing componentA pro

When to stop and call

Stop and call a local company if the outdoor fan is not turning, you see ice that returns after a thaw, you hear grinding or buzzing, you suspect a refrigerant leak, or the breaker trips again. Low refrigerant is a leak problem. It does not get used up. EPA requires technicians who service refrigerant-containing equipment to hold Section 608 certification and prohibits intentionally venting refrigerant, so this is not a job for a handyman or a hardware store kit. Our page on refrigerant leak repair and the guide to refrigerant leaks and R22 explain what to expect.

If it is the middle of a hot night, think about whether it can wait. Our guide on emergency AC repair or waiting until morning helps you decide. Many companies take after-hours calls; ask when you call.

What it may cost

A national cost guide puts a typical AC repair at $150 to $650 per job, with a diagnostic or service call fee of $75 to $200 and a capacitor replacement at $200 to $400. Those are published ranges, not quotes. The full list is in the AC repair cost guide. If the repair quote is large and the system is old, see how to decide between repair and replacement.

A note for hot weeks

During a long run of 100-degree days, many companies are booked and the line may be busy. Have the basics ready when you call: what the system is doing, what you already checked, the approximate age of the unit and whether it has ice or water on it. That saves time and helps the company tell you what kind of visit to expect. Keep the house closed up and shaded in the meantime, and use fans to move air while you wait.

Get a local company on the line

Call now to be connected with a local AC and heating company in Fort Worth.
(817) 623-4802

This site is a free referral service, not an HVAC company. The call connects you with an independent local AC company. Before any work starts, check that the company holds a TDLR air conditioning and refrigeration contractor license on TDLR's online search. For more on the service itself, see AC not cooling in Fort Worth, or find your town on the service areas page.

Frequently asked questions

Why is my AC running but blowing warm air?
Common causes include a dirty filter, a frozen coil, a failed outdoor fan or capacitor, a refrigerant leak or a duct problem. Check the thermostat and filter first, then call a local company if those are fine.
Is it safe to keep running an AC with ice on the lines?
No. Turn it off at the thermostat, set the fan to on to help the ice melt, and replace the filter. If ice returns, the cause is poor airflow or low refrigerant and needs a professional.
Can I add refrigerant myself?
No. EPA requires technicians who service refrigerant-containing equipment to be Section 608 certified, and low refrigerant means there is a leak that needs finding.
What does a no-cooling repair usually cost?
A national cost guide lists a typical AC repair at $150 to $650 per job and a service call fee of $75 to $200. Your quote depends on the failed part.
Who do I call if the power is out?
Call your electric utility. In Oncor areas, Oncor restores service after outages even though you buy power from a retail provider.
Call now to be connected with a local AC and heating company in Fort Worth.
(817) 623-4802

Last updated:

☎ Call (817) 623-4802