A repair quote on an older system raises one question: spend the money here, or put it toward a new unit. This guide gives a practical way to decide, with sourced price ranges and Fort Worth's permit rule.
The decision in one paragraph
Repair is usually the sensible move when the failure is a small part on a system that has otherwise been working well. Replacement deserves a hard look when the repair is a major component, the system is old, it uses R22 refrigerant, or you have been paying for repairs several summers in a row. No fixed formula works for every house, but the steps below give you something concrete to weigh when a local company hands you a number.
Step 1: Find out what failed
Ask the company to name the part and explain why it failed. A national cost guide lists a typical AC repair between $150 and $650 per job, and a capacitor replacement between $200 and $400. At that scale, repairing almost always beats replacing. The picture changes with larger parts. The same guides list evaporator coil replacement at $400 to $2,400 and compressor replacement at $600 to $2,500, with the lower ends applying when the part is under a manufacturer warranty. Our guide to AC repair costs in Fort Worth has the full table with sources.
If the unit is blowing warm air and you have not yet ruled out the simple causes, start with the AC not cooling checklist. A clogged filter or a tripped breaker is a far smaller surprise than a failed compressor.
Step 2: Look at age and condition
Find the data plate on the outdoor unit. It usually shows a model and serial number that tell you roughly how old the system is, and your paperwork may show the install date. Age matters for a few reasons.
- Parts on older systems fail more often, and a second repair soon after the first is common.
- Older systems are usually less efficient than current equipment, which matters when summer highs in Fort Worth normally sit around 95 degrees and the system runs for months.
- Manufacturer warranties on parts and compressors usually have run out, which pushes costs toward the higher end of the sourced ranges.
Do not guess a lifespan from a rule of thumb alone. Condition counts as much as age. A system that has been kept clean and serviced can outlast a neglected one. DOE advises routinely cleaning or replacing filters, checking the evaporator coil every year, clearing debris from the outdoor condenser and keeping the drain channels clear. Those habits are laid out in our AC maintenance checklist.
Step 3: Check the refrigerant
This is the factor that most affects older Fort Worth homes. EPA states that U.S. production and import of R22 has ended, and that owners of existing R22 systems may keep using them for as long as necessary, supplied by recovered and reclaimed refrigerant. In the sourced figures, an R22 recharge runs $180 to $600 per job, against $100 to $320 for R410A, and installed R22 is $90 to $150 per pound against $50 to $80 for R410A.
That does not mean an R22 system must be replaced. EPA says the rules do not restrict continued use of existing systems, which can be serviced and repaired through the end of their useful life. But a system that is low on refrigerant has a leak, and a leak repair with refill is listed at $200 to $1,500. Repeated top-offs on an R22 system add up. Read refrigerant leaks, R22 and newer refrigerants explained for how this works, and ask the company two questions: where is the leak, and can it be fixed at a reasonable cost?
Step 4: Compare the repair against replacement cost
Replacement prices vary far more than repair prices. A Texas price guide gives $3,800 to $4,500 for a 3-ton central AC replacement in a 2,000 square foot home. A national guide gives $5,000 to $12,000 for central AC installation. The gap reflects scope: matching equipment, new ductwork, larger systems and extras all raise the total. Read both figures as a frame, then get a written quote for your own house.
Here is a simple way to use the numbers. Suppose a repair quote is a small share of a replacement quote and the system is otherwise healthy. Repairing is reasonable. Suppose it is a large share, the system is old, and it runs on R22. Then the repair money may be better spent toward the new system. You can see the full range of installation topics on our Fort Worth AC replacement page.
Step 5: Think about what replacement involves
Replacing a system is a bigger job than swapping a part, and it has rules around it.
- Permit. Fort Worth Development Services says that changing, moving or repairing mechanical equipment, including a central heating and air conditioning system, requires a mechanical permit. Applicants must be a registered building contractor, and the city says mechanical contractor applicants must hold a valid State of Texas air conditioning and refrigeration license with proper endorsements. Ask who pulls the permit before you sign anything.
- License. TDLR requires an ACR contractor license for anyone offering air conditioning and refrigeration contracting services in Texas. Use the walkthrough on checking a Texas AC contractor's TDLR license.
- Sizing and ducts. A new outdoor unit on old, leaky ductwork will not perform as it should. Ask whether the ducts and the air handler are part of the plan. Cost ranges for the equipment side are on the AC installation page.
- New refrigerant rules. EPA's technology transitions rule sets a global warming potential limit of 700 for new residential and light commercial air conditioners and heat pumps. New equipment is moving to refrigerants that meet it, which is one more reason replacement is a different job from a repair.
Step 6: Consider a heat pump while you are at it
If the whole system is coming out anyway, it is worth asking about a heat pump. ENERGY STAR describes air-source heat pumps as moving heat rather than generating it, and a ducted unit works like a central air conditioner that runs in reverse for heating. North Texas winters are mild, with DFW normals showing a January low of about 36 degrees and roughly 29 freezing days a year, so a heat pump is a real option for many homes. The tradeoffs are covered in heat pump vs AC and gas furnace in North Texas.
A quick decision checklist
- Get the failed part named in writing, with parts and labor listed.
- Note the system's age and the refrigerant it uses.
- Compare the repair quote with a written replacement quote for the same house.
- Ask how many repairs the system has needed in recent summers.
- If you are leaning toward replacement, confirm the license and the permit before you sign.
If the price of a repair or a replacement is close, the deciding factors are usually how long you plan to stay in the house and how much you want to avoid a breakdown in July.
One last point on timing
If the system still cools and the repair is not urgent, you have time to collect two written quotes and think. If it has failed during a hot stretch, the pressure to decide fast is real, but a repair quote is still worth reading carefully. Ask the company to put the part, the labor and any permit cost on paper, and ask how long the work should take. A clear quote is a good sign, and a vague one is a reason to ask more questions.
Talk to a local company
This site is a free referral service, not an HVAC company. We do not sell or install equipment. The call connects you with an independent local company that can inspect your system and give you a written quote for either path. If the unit is acting up and you are not sure whether to wait, read emergency AC repair or wait until morning. To start with the basics of a repair, see AC repair in Fort Worth.
Frequently asked questions
When is repair clearly the better choice?
Does an R22 system have to be replaced?
Does Fort Worth require a permit to replace an AC?
What does a replacement cost?
Sources
- HomeGuide: How much does AC repair cost?
- HomeGuide: AC evaporator coil replacement cost
- HomeGuide: AC compressor cost
- HomeAdvisor: AC Capacitor Replacement Cost
- HVAC.com: HVAC Replacement Costs in Dallas, TX
- Fixr: How Much Does AC Installation Cost?
- EPA: Residential air conditioning and the phaseout of HCFC-22
- EPA: Technology transitions final rule fact sheet
- U.S. Department of Energy: Home Cooling 101
- City of Fort Worth: Residential permit information
- TDLR: ACR at a Glance
- ENERGY STAR: Air-source heat pumps
- NWS Fort Worth: DFW climate normals
Last updated: