North Texas asks a lot of an air conditioner, and a few basic habits keep it running better. This checklist separates what a homeowner can safely do from what belongs to a pro.
Why maintenance matters here
NWS Fort Worth normals for DFW show a July high of about 95.6 degrees F and an August high of about 95.8, with roughly 20 days a year at 100 degrees or higher. Overnight lows occasionally stay above 80 in summer. Systems here run for months, usually from late spring into fall, so small problems like a dirty filter or a clogged drain get a lot of runtime to cause trouble.
The Department of Energy says annual maintenance can improve comfort and efficiency. Its basic advice is to routinely replace or clean air filters, check the evaporator coil every year and clean it if needed, clear debris from the outdoor condenser, and occasionally pass a stiff wire through the drain channels to prevent clogs. It also says to hire a certified professional when a unit needs more than basic maintenance. The checklist below follows that advice and adds local detail.
Safe things to do yourself
Before touching anything, turn the thermostat to off. If you plan to clean near the outdoor unit, shut off the power at the disconnect box next to it as well. Never open an electrical panel, and never handle refrigerant lines or refrigerant. Those jobs are for a technician.
1. Check the air filter
This is the single most common cause of weak cooling. A clogged filter restricts airflow, which can freeze the evaporator coil and make the system work harder. Look at it monthly during the cooling season. If you can no longer see light through it, replace it. Homes with pets, new construction dust or heavy cottonwood season may need a fresh one more often. Make sure the arrow on the filter frame points toward the air handler.
2. Clear the outdoor condenser
The outdoor unit rejects heat from your house. In the Fort Worth area, cottonwood fluff, grass clippings, leaves and dust can coat the fins and block airflow. Keep plants and fences back from the unit so air can move freely, and clear loose debris from the top and sides. With the power off, you can rinse the fins gently with a garden hose from the outside. Do not use a pressure washer, because it flattens the fins. If hail has bent a lot of fins, that is a job for a technician with a fin comb.
3. Check the pad
Clay soil around North Texas expands and shrinks with moisture, and a condenser pad can tilt over time. A unit that sits crooked may strain its refrigerant lines or drain oil unevenly. If the pad looks off level or has sunk, mention it when you call someone. Do not try to jack the unit up yourself.
4. Look at the drain line
The condensate drain carries water away from the indoor coil. The DOE suggests occasionally passing a stiff wire through the drain channels. Many homes also have a cleanout tee near the air handler. If water is pooling in the secondary pan, dripping from a ceiling near the air handler, or the system has shut off by itself, read our guide on AC drain line clogs and water around the air handler. Stop the system if water is leaking into the ceiling.
5. Check the thermostat
Confirm the thermostat is set to cool, the fan is on auto, and the setpoint is below room temperature. Replace the batteries if it uses them. A blank display often just needs new batteries. A thermostat that behaves strangely may need repair or replacement, which our thermostat repair and installation page covers.
6. Walk the house
Check that supply registers and return grilles are open and not blocked by furniture or rugs. Note any room that is much hotter than the others, any rattling or whistling at the vents, and any musty smell. These are useful details to give a technician later.
What belongs to a professional
Some maintenance should be done by a trained technician. A tune-up visit typically includes checking the evaporator coil, cleaning it when needed, inspecting electrical connections and capacitors, testing the blower, measuring airflow and temperature drop, and checking the refrigerant charge. The refrigerant part is regulated: EPA requires technicians who service refrigerant-containing equipment to hold Section 608 certification, and it prohibits intentionally venting refrigerant.
A pro visit is also the right time to ask about attic conditions. Many homes in Fort Worth have the air handler and ductwork in the attic, where summer heat is brutal on insulation, duct joints and wiring. Loose duct connections and crushed flex duct are easy to miss from the living space. If ducts are a concern, see our page on ductwork repair and replacement.
For what to expect to pay, a national figure from HomeGuide puts an AC tune-up or maintenance visit at about $70 to $200 per visit. That is a national range, not a Fort Worth quote, so ask any company what is included before you agree.
A simple seasonal schedule
| When | What to do |
|---|---|
| Early spring | Replace the filter, clear the condenser, check the pad, test the system before the first hot days, and consider scheduling a professional tune-up. |
| Each month in summer | Look at the filter, listen for new noises, glance at the drain pan, and keep the condenser clear of cottonwood fluff. |
| After a storm | Check the outdoor unit for debris and hail damage, and reset the breaker only if it tripped once. Repeated trips need a technician. |
| Fall | Replace the filter, and if you have a gas furnace or heat pump, test the heat before the first cold front. |
| Before a freeze | Confirm the furnace or heat pump starts, and know where your CO alarms are. |
Winters here are mild, with a normal January low around 36 degrees F and about 29 freezing days a year, but cold fronts can arrive fast. Heating systems get used less than cooling, which means a furnace can sit untested for months. The Consumer Product Safety Commission advises having the heating system professionally inspected and serviced annually, and recommends CO alarms on every level of the home and outside sleeping areas. If you ever smell gas, leave, call 911, and call the gas utility from outside.
Signs it is time to call someone
- The system runs but the air from the vents is not cool. Start with our AC not cooling checklist.
- Ice on the refrigerant line or indoor coil.
- A burning smell, repeated breaker trips or a loud buzzing from the outdoor unit.
- Water around the air handler after you have cleared the filter.
- Higher bills with no change in how you use the system.
An older system that needs repeated repairs may reach a point where replacement is the better choice. Our guide on repair or replace your AC covers the decision. For a routine visit, look at our AC maintenance and tune-up page. To help you through the hottest weeks, see our guide to getting your AC through a North Texas summer.
Choosing a company
Whoever does the maintenance should hold a TDLR air conditioning and refrigeration contractor license, and you can check it on TDLR's license search. Our license check guide shows how. This site is a free referral service, not an HVAC company. Calling the number on this page connects you with an independent local company, and you can also see which towns we cover.
Frequently asked questions
How often should I change my AC filter?
Can I clean the outdoor unit myself?
How much does an AC tune-up cost?
When is the best time for maintenance?
Sources
Last updated: